Building Addition

Fascia

Arcedges offers two types of Fascia

  • Parapet / Flush
  • Cantilevered with three sheeting options - straight, bottom curved and top & bottom curved
Roof Monitor

Arcedges standard roof monitor has a throat width of 1.5 M and a height of 1.0 M, made from hot rolled sections. Panels for roof monitor will be the same as supplied for main building unless otherwise specified. We can also supply roof monitor of varied sizes as per client’s requirements.

Mezzanine Floor

Arcedges standard mezzanine floor consists of joists, beams, intermediate columns and galvanized profiled decking sheets. Decking sheets are profiled from pre-galvanized coils. For larger column free spaces, we also offer composite design with shear connectors.

Roof Extensions

Arcedges standard roof extensions are 1.5 M wide, which are achieved by extending the end bay purlins beyond the end wall steel line. We can also provide Soffit panels, if required by the client.

Canopies

Arcedges standard canopies are 1.5 M wide and can be provided at eave or any height below the eave. If required, Soffit panels can also be provided. Rafters for canopies are made from hot rolled or built-up I sections.

Crane Systems

Arcedges designs buildings to support various crane systems, such as EOT, Monorail, Under Hung, Jib etc. Overhead cranes of upto 25MT are generally supported with brackets. For capacities more than 25 MT, a stepped column/independent support system is provided.

For Arcedges to provide the best and the most economical solution, the following crane data need to be assessed:

  • Location of crane with travel length
  • Centre to centre distance of crane rails
  • Crane Hook height
  • Wheel loads
  • Vertical and horizontal clearances
  • Wheel base and bumper distances
  • Type of crane operations
  • No of cranes operating in a single bay

In case of the above data not furnished by the client, standard Electromech Crane Data is used upon client’s approval.

Interior Partitions and Roof Platforms

Interior partitions are non-load bearing walls meant to serve as dividers within a building. Partitions are constructed from 200 deep built-up columns and flush girts and can be located in either transverse or longitudinal directions. These may be sheeted on either side or on one side with normal wall cladding profiles.